The Funtoo Linux project has transitioned to "Hobby Mode" and this wiki is now read-only.
Difference between revisions of "Install/Setting the Date/en"
(Updating to match new version of source page) |
(Updating to match new version of source page) |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
<includeonly> | |||
== Setting the Date == | |||
</includeonly><noinclude><languages/> | |||
= Install Guide: Setting the Date = | |||
{{Important|If your system's date and time are too far off (typically by months or years, | {{InstallNavigation|num=7|prev=Mounting Filesystems|next=Download and Extract Stage3}}</noinclude> | ||
{{Important|If your system's date and time are too far off (typically by months or years), then it may prevent Portage from properly downloading source tarballs. This is because some of our sources are downloaded via HTTPS, which use SSL certificates and are marked with an activation and expiration date. However, if your system time is relatively close to correct, you can probably skip this step for now.}} | |||
Now is a good time to verify the date and time are correctly set to UTC. Use the {{c|date}} command to verify the date and time: | Now is a good time to verify the date and time are correctly set to UTC. Use the {{c|date}} command to verify the date and time: | ||
| Line 17: | Line 22: | ||
{{console|body=###i## hwclock --systohc}} | {{console|body=###i## hwclock --systohc}} | ||
<noinclude>{{InstallNavigation|num=7|prev=Mounting Filesystems|next=Download and Extract Stage3|align=right}}</noinclude> | |||
Latest revision as of 18:27, September 9, 2020
Install Guide: Setting the Date
| Install Guide, Chapter 7 | < Prev | Next > |
If your system's date and time are too far off (typically by months or years), then it may prevent Portage from properly downloading source tarballs. This is because some of our sources are downloaded via HTTPS, which use SSL certificates and are marked with an activation and expiration date. However, if your system time is relatively close to correct, you can probably skip this step for now.
Now is a good time to verify the date and time are correctly set to UTC. Use the date command to verify the date and time:
root # date Fri Jul 15 19:47:18 UTC 2011
If the date and/or time need to be corrected, do so using date MMDDhhmmYYYY, keeping in mind hhmm are in 24-hour format. The example below changes the date and time to "July 16th, 2011 @ 8:00PM" UTC:
root # date 071620002011 Fri Jul 16 20:00:00 UTC 2011
Once you have set the system clock, it's a very good idea to copy the time to the hardware clock, so it persists across reboots:
root # hwclock --systohc
| Install Guide, Chapter 7 | < Prev | Next > |