Note
The Funtoo Linux project has transitioned to "Hobby Mode" and this wiki is now read-only.
Difference between revisions of "Draft Funtoo Install on RPI"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
== Introduction == | |||
== Introduction == | == Introduction == | ||
== Installation Overview == | == Installation Overview == | ||
# [[Draft_Funtoo_Install_on_RPI/Partition and Format an SDCard]] | # [[Draft_Funtoo_Install_on_RPI/Partition_and_Format|Partition and Format an SDCard]] | ||
# [[Draft_Funtoo_Install_on_RPI/Install the Stage 3 Tarball]] | # [[Draft_Funtoo_Install_on_RPI/Stage3_Install|Install the Stage 3 Tarball]] | ||
# [[Draft_Funtoo_Install_on_RPI/Install the Firmware]] | # [[Draft_Funtoo_Install_on_RPI/Firmware|Install the Firmware]] | ||
# [[Draft_Funtoo_Install_on_RPI/Configure Your System]] | # [[Draft_Funtoo_Install_on_RPI/Configure Your System]] | ||
# [[Draft_Funtoo_Install_on_RPI/Install Binary Kernel, Modules and dtbs]] | # [[Draft_Funtoo_Install_on_RPI/Install Binary Kernel, Modules and dtbs]] | ||
Revision as of 19:51, February 9, 2019
Introduction
Introduction
Installation Overview
- Partition and Format an SDCard
- Install the Stage 3 Tarball
- Install the Firmware
- Draft_Funtoo_Install_on_RPI/Configure Your System
- Draft_Funtoo_Install_on_RPI/Install Binary Kernel, Modules and dtbs
- Draft_Funtoo_Install_on_RPI/Deploy Installation to SDCard
- Draft_Funtoo_Install_on_RPI/Transfer the SDCard to the Raspberry Pi and Boot
- Draft_Funtoo_Install_on_RPI/Enjoy!