The Funtoo Linux project has transitioned to "Hobby Mode" and this wiki is now read-only.
Talk:Undead USB Install
undead really targets USB, SSD, and NVME. Swapping is best handled in a file or turned off.
https://www.funtoo.org/Talk:Install/GPT_Partitioning <--correct partitioning to load legacy mode, and uefi mode.
/etc/fstab reads filesystem labels and ignores partition names. file browsers read partition labels, so were using FUNTOO for the root drive so our branding is correct in file browsers.
root # mkfs.vfat -F 32 /dev/sdc2 root # fatlabel /dev/sdc2 "BOOT" OR root # mlabel -i /dev/sdc2 ::"BOOT"
jfs is amazingly fast, use it!
https://www.phoronix.com/scan.php?page=article&item=9way_linux317_fs&num=2
root # mkfs.jfs /dev/sdc3 root # jfs_tune -L "FUNTOO" /dev/sdc3
root # mount /dev/sdc3 /mnt/funtoo root # mkdir /mnt/funtoo/boot root # mount /dev/sdc2 /mnt/funtoo/boot
STOP HERE!!! go back to Undead_USB_Install now and start from the top code block.
Come back at DONE! to have the legacy chicken lay the uEFI egg.
root # mkdir /boot/efi root # mount /dev/sdc2 /boot/efi root # grub-install --target=x86_64-efi /boot/efi root # grub-install --target=i386-efi /boot/efi
i386-efi is untested but legacy mode + 64 uefi from legacy are working at this point of the install.
gparted
gparted isn't granular enough to make bios boot partitions to load legacy mode in GPT. Device > create partition table > GPT
/dev/sdc1 name: "BOOT Bios" size: 1MiB flags: bios_grub
/dev/sdc2 name: "BOOT" file system: fat32 label: BOOT size: 128MiB flags: boot, esp
/dev/sdc3 name: "funtoo" file system: jfs label: ROOT size: 14.9GiB
/etc/fstab label grabs the file system label, not the drive name. you should be able to name the root drive funtoo, and have it show up as that in other operating systems when the usb is inserted.