Encrypted funtoo on linode

This howto describes how to setup a complete Funtoo Encrypted Install ( Root File System and SWAP ) using LUKS and LVM on LINODE VPS

   Note

Use Funtoo Installation Guide for reference.

   Important

This howto is a compilation of steps. If you find any discrepancy blame pfctl on #Funtoo @ Freenode.
Work smarter not Harder.

Setting Linode

• From Linode Manager create a new Linode. Under the Disks section of the Linode Dashboard, click on "Create a new Disk:"

• Label your new disk image and choose an appropriate size. Here we will create "two disks" the first for root partition and another for swap. Set appropriate size for each one.

• Select the Create a New Configuration Profile option. Assign a label, and select your disk images under Block Device Assignment.

Click on Save Changes once your profile is complete.

• Return to the Linode DashBoard, and select the Rescue tab. From there, click the Reboot Into Rescue Mode button. Your Linode will now boot into the Finnix recovery image. Use the Lish shell to access your Linode.

• Run the following set of commands to create a root password and enable SSH server:

root # passwd ↵
root # service ssh start ↵

   {{{title}}}

{{{body}}}

Prepare Hard Disk and Partitions

root # sgdisk --zap-all /dev/sda ↵

Creating new GPT entries.
GPT data structures destroyed! You may now partition the disk using fdisk or
other utilities.

Now we will use fdisk to create the MBR partition table and partitions:

root # fdisk /dev/sda

Within fdisk, follow these steps:

Empty the partition table:

Command (m for help): o ↵