The Funtoo Linux project has transitioned to "Hobby Mode" and this wiki is now read-only.
Install/Creating Filesystems/es
Guia de instalación: Creando el sistema de archivos
| Install Guide, Chapter 5 | < Prev | Next > |
Esta sección cubre instalaciones con BIOS y con UEFI. ¡No se la salte!
Antes de poder utilizar las particiones recién creadas, los dispositivos de bloque que fueron creados en el paso anterior, necesitan ser inicializados con un sistema de archivos de "metadatos". Este proceso es conocido como "creación de un sistema de archivos" en los dispositivos de bloque, estos pueden ser montados y usados para almacenar archivos.
Vamos a mantener esto simple. ¿Está usted usando particiones MBR de la vieja escuela? Si es así, vamos a crear un sistema de archivos ext2 en /dev/sda1:
root # mkfs.ext2 /dev/sda1
If you're using GPT partitions for UEFI, you'll want to create a vfat filesystem on /dev/sda1, because this is what UEFI is able to read:
root # mkfs.vfat -F 32 /dev/sda1
Now, let's create a swap partition. This partition will be used as disk-based virtual memory for your Funtoo Linux system.
You will not create a filesystem on your swap partition, since it is not used to store files. But it is necessary to initialize it using the mkswap command. Then we'll run the swapon command to make your newly-initialized swap space immediately active within the live CD environment, in case it is needed during the rest of the install process:
root # mkswap /dev/sda2 root # swapon /dev/sda2
Root Filesystem
Now, we need to create a root filesystem. This is where Funtoo Linux will live. We generally recommend ext4 or XFS root filesystems.
Keep in mind that some filesystems will require additional filesystem tools to be emerged prior to rebooting. Please consult the following table for more information:
| Filesystem | Recommended as root file system? | Additional tools required to emerge |
|---|---|---|
| ext4 | Yes | None |
| XFS | Yes | sys-fs/xfsprogs |
| zfs | No - advanced users only | sys-fs/zfs |
| btrfs | No - advanced users only | sys-fs/btrfs-progs |
We do not recommend users set up ZFS or BTRFS as their root filesystem. This is much more complex and usually not necessary. Instead, choose XFS or ext4. We do support ZFS or BTRFS as non-root filesystems and this is much, much easier to configure. See ZFS and BTRFS after you are done setting up your Funtoo Linux system to configure ZFS or BTRFS for additional secondary storage.
If you're not sure, choose ext4. Here's how to create a root ext4 filesystem:
root # mkfs.ext4 /dev/sda3
...and here's how to create an XFS root filesystem, if you prefer to use XFS instead of ext4:
root # mkfs.xfs /dev/sda3
Your filesystems (and swap) have all now been initialized, so that that can be mounted (attached to your existing directory heirarchy) and used to store files. We are ready to begin installing Funtoo Linux on these brand-new filesystems.