Install/BootLoader

   Note

This is a template that is used as part of the Installation instructions which covers: boot loader configuration. Templates are being used to allow multiple variant install guides that use most of the same re-usable parts.

Installing a Bootloader

These install instructions show you how to use GRUB to boot using BIOS (old-school) or UEFI (new-school). As of boot-update-1.7.2, now in Portage, the steps are very similar.

First, emerge boot-update. This will also cause grub-2 and efibootmgr to be merged, since they are dependencies:

(chroot) # emerge boot-update

Then, edit /etc/boot.conf using nano and specify "Funtoo Linux genkernel" as the default setting at the top of the file, replacing "Funtoo Linux".

/etc/boot.conf should now look like this:

boot {
	generate grub
	default "Funtoo Linux genkernel" 
	timeout 3 
}

"Funtoo Linux" {
	kernel bzImage[-v]
}

"Funtoo Linux genkernel" {
	kernel kernel[-v]
	initrd initramfs[-v]
	params += real_root=auto 
} 

"Funtoo Linux better-initramfs" {
	kernel vmlinuz[-v]
	initrd /initramfs.cpio.gz
}

If you are booting a custom or non-default kernel, please read man boot.conf for information on the various options available to you.

Old School (BIOS) MBR

When using "old school" BIOS booting, run the following command to install GRUB to your MBR, and generate the /boot/grub/grub.cfg configuration file that GRUB will use for booting:

(chroot) # grub-install --target=i386-pc --no-floppy /dev/sda
(chroot) # boot-update

New School (UEFI) Boot Entry

If you're using "new school" UEFI booting, one run of the following sets of commands, depending on whether you are installing a 64-bit or 32-bit system. This will add GRUB as a UEFI boot entry.

For x86-64bit systems:

(chroot) # grub-install --target=x86_64-efi --efi-directory=/boot --bootloader-id="Funtoo Linux [GRUB]" --recheck /dev/sda
(chroot) # boot-update

For x86-32bit systems:

(chroot) # grub-install --target=i386-efi --efi-directory=/boot --bootloader-id="Funtoo Linux [GRUB]" --recheck /dev/sda
(chroot) # boot-update

In the future...

OK -- you are ready to boot!

You only need to run grub-install when you first install Funtoo Linux, but you need to re-run boot-update every time you modify your /etc/boot.conf file or add new kernels to your system. This will regenerate /boot/grub/grub.cfg so that you will have new kernels available in your GRUB boot menu when you reboot.