The Funtoo Linux project has transitioned to "Hobby Mode" and this wiki is now read-only.
Power Management
Note: This page is a work in progress.
Use case
The majority of people who will be interested in power management on Funtoo will be split into the following two cases:
- Laptop users
- Low Power Workstation/Server users
This article is currently almost exclusively directed at laptop users.
The trade-off
First of all, you need to decide how much performance (if any) you're willing to sacrifice for a reduction in power.
Tools like laptop-mode and cpufreqd can cause a reduction in performance, however with careful configuration you can make this minimal while maintaining most of the benefits. Throughout this guide make sure to read comments in configuration files and decide what you need and want.
Getting started
Using Gentoo's resources
You'll find a fantastically written starter guide on the Gentoo site [1], note however that you are not required to use Gentoo-Sources. (Making your own kernel is a boatload of fun though! You're missing out.)
Laptop-mode-tools
Laptop-mode-tools should be reasonably well configured out of the box.
vim /etc/laptop-mode/laptop-mode.conf
Make sure it's enabled:
############################################################################### # Enable/Disable laptop-mode-tools execution # ------------------------------------------ # Set it to 0 to completely disable laptop-mode-tools from running ############################################################################### # ENABLE_LAPTOP_MODE_TOOLS=1
Next declare when to use laptop-mode:
# Enable laptop mode when on battery power. # ENABLE_LAPTOP_MODE_ON_BATTERY=1 # Enable laptop mode when on AC power. # ENABLE_LAPTOP_MODE_ON_AC=0
Next you will probably be safe to enable AUTO_MODULES with:
ENABLE_AUTO_MODULES=1
However, provided you're not using HAL (You shouldn't be, it's deprecated and is replaced by udev) you may want to disable the HAL module explicitly:
vim /etc/laptop-mode/conf.d/hal-polling.conf ---- CONTROL_HAL_POLLING=0
Finally, lets start up laptop_mode, then add it to our init.
/etc/init.d/laptop_mode start rc-update add laptop_mode default
Triggering events upon power state/level
You can set up certain events to happen when a particular power state is reached through the use of udev rules. For example if you have a laptop and want it to hibernate (using sys-power/hibernate-script) when the battery reaches a low level (1%) then you can do the following:
Find the power supplies on the system:
root # ls /sys/class/power_supply
Find the parameters for each:
root # udevadm info --attribute-walk /sys/class/power_supply/[what previous command gave you, eg AC]
Using this information you can then create a rule:
/etc/udev/rules.d/99-lowbat.rules ## HIBERNATE IF BATTERY IS LOW
SUBSYSTEM=="power_supply", ATTR{type}=="Battery", ATTR{status}=="Discharging", ATTR{capacity}=="1", RUN+="/usr/sbin/hibernate"
To load this new rule:
root # udevadm control --reload